download the new for mac Domain Checker 7.7

Note: The dual-Ethernet port series support the above three configurations and supports functions as multiple-access, fault-tolerance and load balancing. Main Network Card: Please select eth0/eth1 (optional).after enable multiple access function.Default Network Card: Please select eth0/eth1/bond0(optional) after enable multiple-access function.Please note these two cards shall be in the same LAN. The system is shown as offline once these two cards are both offline.

The eth0 and eth1 are both working now and bearing the network load.

Load balance: In this mode, device uses bond0 to communicate with the external device.

Usually there is only one running card (master card).System can enable alternate card when the master card is malfunction. At the same time, you need to set one master card.

Network fault-tolerance: In this mode, device uses bond0 to communicate with the external devices.

In multiple-address mode, system network status is shown as offline once one card is offline. Usually you need to set one default card (default setup is etho) to request the auto network service form the device-end such as DHCP, email, FTP and etc. You can use the services such as HTTP, RTP service via etho0 or the eth1.

Multiple-address mode: eth0 and eth1 operate separately.

Network Mode : Includes multiple access, fault tolerance, and load balancing.

The single network adapter interface is shown as in Figure 4‑99 and the dual network adapters interface is shown as in Figure 4‑100.

Download the new for mac Domain Checker 7.7